Blumat Irrigation for Pots
IG19398V
Normaler Preis $15.12/
zzgl. Versandkosten
Build the exact Blumat irrigation kit your pots need — from 1-gallon seedling containers to 200-gallon living soil setups. Choose your sensor size, calibration type, and water distribution method. No timers, no electricity, no daily watering.
Sensor Size ＋
- 5" Sensor — Senses moisture at the soil surface. Best for pots under 10 gallons or shallow-rooted crops.
- 9" Sensor — Adjustable depth up to 9 inches. Better moisture control for larger containers and deep root zones.
Calibration Type ＋
- Standard — Ships as-is from Blumat. You dial in the moisture level yourself. Includes 6" of 3mm tubing (5" sensor) or 2 ft (9" sensor).
- Preset — Pre-calibrated at the factory for most soil and potting mix types. Just insert and go. Includes locking adjustment cap, 3mm union, adjustment key, and extra 2 ft of 3mm tubing.
Distribution Method ＋
- None (1–5 gal) — Sensor waters directly at the insertion point. Best for small pots.
- 5" Drip Ring (2–7 gal) — 4 drip points, pre-assembled.
- 3-Dripper Setup (5–20 gal) — 3 drippers with stakes and 3mm tubing.
- 10" Drip Ring (10–20 gal) — 8 drip points, pre-assembled.
- 5-Dripper Setup (10–30 gal) — 5 drippers with stakes and 3mm tubing.
- BluSoak Tape Loop (30–90 gal) — Single loop for even coverage around large containers.
- BluSoak Tape Double Spiral (30–90 gal) — Spiral from center outward for maximum coverage.
- BluSoak Tape Triple Spiral (100–200 gal) — Largest spiral layout for very big pots and beds.
What's Included ＋
- 1 Blumat sensor (5" or 9" based on selection)
- 3mm drip tubing (6" or 2 ft based on sensor size)
- Distribution components based on selection (drip ring, drippers, or BluSoak tape)
- Preset upgrade includes: locking adjustment cap, 3mm union, adjustment key, extra tubing
What You'll Also Need ＋
This kit covers everything at the pot. To complete your system you’ll also need an 8mm supply line and a water source:
- 8mm Supply Line — runs from your water source to the sensor. See our 8mm SuperFlex Supply Line Kits.
- Gravity Reservoir — our complete 5-Gallon Deluxe Bucket Kit comes pre-drilled and ready to connect, or grab our 8mm Bulkhead Fittings and use any container of your choosing.
- Pressurized Source (hose bib or pump) — if connecting to a hose bib or pump instead of a gravity reservoir, you’ll need a Pressure Reducer to bring the pressure down to the safe Blumat operating range of 7–15 PSI.
How It Works ＋
The Blumat sensor is a ceramic cone that reads soil moisture. As the soil dries, a vacuum builds inside the cone and pulls water through the drip line. When moisture is restored, the valve closes automatically.
Connect your sensor to any 8mm Blumat supply line running from a gravity reservoir or pressurized source. No programming, no timers, no electricity required.
