Whole System Adjustable Pressure Reducer for Blumat systems
IG18898
Regular price $140.40/
Shipping calculated at checkout.
Full control over your Blumat system pressure. Adjustable from 2–14 PSI with a built-in gauge so you always know exactly what your system is running — the most important number to know in any Blumat setup.
Key Features ＋
- Built-in 0–30 PSI pressure gauge for real-time monitoring
- High flow rate of over 5 gallons per minute — can replace six or more standard Blumat pressure reducers
- Adjustable from 2–14 PSI to match any distribution method (drippers, drip rings, BluSoak)
- Powerful enough for the largest systems, precise enough for single-zone setups
Connections & Adapters ＋
The reducer body has a ½" male pipe thread (MPT) inlet and a ¾" female pipe thread (FPT) outlet. Included adapters make it easy to install:
- Input — ¾" PVC swivel adapter for standard garden hoses or hose bibs
- Output — ¾" to ½" Perma-Loc fitting for Trunk Line Kits
- Output — ¾" to 8mm adapter for Supply Line Kits with SuperFlex tubing
- Also includes — ¾" FPT tee and 1/4" to ¾" MBT bushing
Installation Instructions ＋
- Tape all male fittings with the provided tape, wrapping 5–6 times clockwise.
- Assemble parts as pictured in the instruction diagram.
- Connect to a valve on a pump kit or to a hose bib using the provided ¾" swivel adapter.
- Using the provided fittings, connect to your Blumat system supply line.
- Open the incoming water to check current system pressure. Recommended ranges:
- Drip rings — 12–15 PSI
- BluSoak — 7–10 PSI
- To adjust pressure: turn off incoming water, release system pressure by opening a valve on the Blumat supply line until the gauge reads 0, then turn the black adjustment collar (tighten for more pressure, loosen for less).
- Close the Blumat supply line valve and open incoming water to re-pressurize. Check the gauge. If not in range, repeat steps 6–7 until correct.
